User Tools

Site Tools


products:jtagserial_programmer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
products:jtagserial_programmer [2020/01/21 13:13]
po [Setup]
products:jtagserial_programmer [2020/06/30 20:24] (current)
po [Error: contents differ]
Line 210: Line 210:
 </code> </code>
  
-4-byte addresses is not implemented in latest openocd jtagspi driver (20190116), use the following temporary workaround patch to revert to 3-byte addresses commands:+"contents differ" error: 4-byte addresses is not implemented in latest openocd jtagspi driver (20190116), use the following temporary workaround patch to revert to 3-byte addresses commands:
  
 {{ :tools:flashid.patch |}} {{ :tools:flashid.patch |}}
-<code bash>+<code>
 cd openocd cd openocd
 git apply flashid.patch git apply flashid.patch
 make make
 sudo make install sudo make install
 +</code>
 +
 +**Important note:** After applying the patch, these warnings are fine as long as you dont get "contents differ" errors !
 +<code>
 +Warn : device needs paging or 4-byte addresses - not implemented
 </code> </code>
products/jtagserial_programmer.1579608783.txt.gz ยท Last modified: 2020/01/21 13:13 by po